Hello. I wasn’t sure the best place to report this, but I’m having problems powering up my nrf9160 feather v4 board from my macbook with a USB C to C cable. I’ve tried a few known good cables and both orientations, but the board will not power up. If I use a C to A adapter on an A to C cable, that will power up the board. I’m wondering if there’s a problem with how the CC1/CC2 pins are hooked up. It looks like the schematic on github was last updated for v2, so I can’t check there, and I don’t have access to most of my usual test equipment right now except a cheap multimeter, but I’m getting 0v between vusb and gnd. My laptop charger and phone charger (both USB C, not A) also refuse to power up the board.