When Connecting the board, it does not show up anywhere

jhox616

Hey Jared,

I used nRF Connect extension when I was building blinky. the build was successful but my issue is that the board is not detected anywhere even with pyocd when I used pyocd list to check if there is a board connected. Is there a driver for nRF boards that I could install so the board could get detected? Is the driver different for the 9160 and and 9151?

PS. I also did install SEGGER j-link and still did not detect the board both version 8.52 and 8.18

jaredwolff

@jhox616 yes the boards are different. nRF9151 uses probe-rs and the nRF9160 uses Circuit Dojo: Zephyr Tools to load. You can build both with either nRF Connect for VSCode or Circuit Dojo: Zephyr Tools but it’s harder to load code to the nRF9160 when using nRF Connect for VSCode