- Edited
You can also check nfed/samples/at_client/build/zephyr to see if app_update.bin is there. (That’s where it’s pulled from) Since you’re using the NFED version, it should be building the sample with app_update.bin
Issue with the Load via Bootloader Task
- Edited
Jared,
Thank you for your help. I am using the Zephyr plug-in v0.1.17
The code does seem to be in nfed/samples/at_client
I do not see an app folder.
I executed the change project command and build - all completed successfully. But, when I went to load via bootloader, I get the message above. Not sure what I can give you for “full output” but happy to do so.
I do see app_update.bin in the /nfed/samples/at_client/build/zephyr folder.
Thanks,
Chip
- Edited
chipmc that’s good it’s in nfed/samples/at_client. Now, to figure out why it can’t be found!
chipmc I executed the change project command and build - all completed successfully. But, when I went to load via bootloader, I get the message above. Not sure what I can give you for “full output” but happy to do so.
Ahh, right there isn’t any output on a failure like that. One thing you an confirm, can you run the Zephyr Tools: Change Project and select at_client? It’s very possible that it’s pointing to the wrong directory thus the failure.
In the nfed folder can you also run git status -u
Ahh found it. Try the Load and Monitor command. There was something in Load that I didn’t change over.
Give this one a whirl. Should fix your problem on the Zephyr Tools: Load command.
Instructions on manual install: https://stackoverflow.com/questions/42017617/how-to-install-vs-code-extension-manually
- Edited
Jared,Progress but not quite there.
It no longer complains about the app_update.bin and the loading progress bar shows up. But it times out and gives the following errors:
Load Error! Did you Init your project?and
> Executing task: newtmgr -c vscode-zephyr-tools image upload /Users/chipmc/Documents/Maker/Zephyr/Demo/nfed/samples/at_client/build/zephyr/app_update.bin <
0 B / 133.63 KiB [-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------] 0.00%Error: NMP timeout
The terminal process "bash '-c', 'newtmgr -c vscode-zephyr-tools image upload /Users/chipmc/Documents/Maker/Zephyr/Demo/nfed/samples/at_client/build/zephyr/app_update.bin'" terminated with exit code: 1.
Terminal will be reused by tasks, press any key to close it.I am now running v 0.1.18
Chip
- Edited
chipmc make sure
- You didn’t overwrite the bootloader (I assume you have not used a programmer to overwrite it)
- The device is in bootloader mode (blue led is solid)
- You don’t have any open serial monitoring to your port
- Newmgr is configured with the correct port
Almost there!
Right, well I was not aware that you can’t have another device with a serial monitor. Thought that selecting the device port in Newtmgr was enough.
Once I disconnected the other device, the upload went smoothly so in summary:
- Zephyr Plugin v0.1.18
- No other devices on Serial follow
Thank you for your help, on with the Golioth demo example!
Chip
chipmc excellent!!